Makita LS1030N Spécifications

Naviguer en ligne ou télécharger Spécifications pour Scies à onglets Makita LS1030N. Makita LS1030N Specifications Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
SPECIFICATIONS
Model LS1030N
Blade diameter .....................................................................................................................255 mm — 260 mm
Hole (arbor) diameter
For all countries other than European countries ............................................................. 25.4 mm and 25 mm
For European countries ......................................................................................................................... 30 mm
Max. cutting capacities (H x W) with blade 260 mm in diameter
No load speed (min
–1
) ............................................................................................................................... 4,600
Dimensions (L x W x H) ........................................................................................530 mm x 476 mm x 532 mm
Net weight ...................................................................................................................................................11 kg
Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
Note: Specifications may differ from country to country.
Power supply
The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets without earth wire.
Miter angle
Bevel angle
45° (left and right)
90.5 mm x 95 mm
69 mm x 135 mm
90.5 mm x 67 mm
69 mm x 95 mm
Miter Saw
LS1030N
Vue de la page 0
1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1 - Miter Saw

SPECIFICATIONS Model LS1030NBlade diameter ...

Page 2

10If some part contacts the vise, re-position the visearm. Press the workpiece flat against the guidefence and the turn base. Position the workpiece a

Page 3

11MAINTENANCECAUTION: Always be sure that the tool is switched off andunplugged before carrying out any work on the tool. Alignment for squareness (Fi

Page 4

Makita CorporationAnjo, Aichi, JapanMade in China884146A8

Page 5 - 70 mm 70 mm 137 mm

2123 435687691181010121234567813514

Page 6

391011 1213 1415 16135 mm151617181921223232524262720

Page 7 - ENGLISH

42829322230313322534353637292937383940304342424117 1819 2021 2223 24

Page 8 - OPERATING INSTRUCTIONS

52947363048271249505144464546137 mm70 mm 70 mm 137 mm90 mm40 mm2526 2728 2930

Page 9

6SymbolsThe following show the symbols used for the tool. Be sure that you understand their meaning before use.❏ Read instruction manual.❏ DOUBLE INSU

Page 10 - Operation

7ENGLISH Explanation of general view 1Bolt 2 Center cover 3 Socket wrench 4 Shaft lock 5Loosen 6Arrow 7 Blade case 8 Saw blade 9Spindle 10 Flange 11 R

Page 11 - MAINTENANCE

820. Check damaged parts Before further use of the tool, a guard or other partthat is damaged should be carefully checked todetermine that it will ope

Page 12 - Makita Corporation

9CAUTION: • For all countries other than European countries(Fig. 6)The silver ring 25.4 mm in outer diameter is factory-installed onto the spindle. Th

Commentaires sur ces manuels

Pas de commentaire