Makita SP6000 Manuel d'instructions

1 ENGLISH (Original instructions) INSTRUCTION MANUAL DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE TH

10 with scale plate. Make sure that the lock pin fits in the groove. Press the shaft lock fully so that the blade cannot revolve and use the wrench to

11 When bevel cutting with the guide rail, slide the slide lever on the tool base so that the tool does not fall down on its side. 1 007666 Move the

12 1 007667 1 007668 NOTE: • Adjusting for accuracy of 22.5° , 48° and -1° cut cannot be performed. Replacing carbon brushes 1 001145 Remove

13

14

15

16 Makita Corporation Anjo, Aichi, Japan 884683F228

2 ENGLISH (Original instructions) SPECIFICATIONS Model SP6000 Blade diameter 165 mm at 90° 56 mm at 45° 40 mm Max. cutting depth at 48° 38 mm No l

3 2006/42/EC from 29th December 2009 And are manufactured in accordance with the following standards or standardised documents: EN60745 The technical

4 power tool will do the job better and safer at the rate for which it was designed. 18. Do not use the power tool if the switch does not turn it on

5 toward the operator; − if the blade becomes twisted or misaligned in the cut, the teeth at the back edge of the blade can dig into the top surface

6 000194 • Never force the saw. Forcing the saw can cause uneven cuts, loss of accuracy, and possible kickback. Push the saw forward at a speed so

7 19. Do not stop the blades by lateral pressure on the saw blade. 20. Always use blades recommended in this manual. Do not use any abrasive wheels.

8 Tilting to the right 1 007659 Turn the positive stopper so that the arrow on it points one of two positions (vertical for 22.5°, horizontal for 45

9 The tool speed can be infinitely adjusted between 2,000 and 5,200 rotations per minute by turning the adjusting dial. Higher speed is obtained when