Makita DCS 6800I Manuel d'utilisateur télécharger pdf (Page 21)

STOP

AVOID SKIN AND EYE CONTACT

Mineral oil products degrease your skin. If your skin comes in

contact with these substances repeatedly and for an extended

period of time, it will desiccate. Various skin deseases may

result. In addition, allergic reactions are known to occur.

Eyes can be irritated by contact with oil. If oil comes into your

eyes, immediately wash them with clear water.

If your eyes are still irritated, see a doctor immediately!

Refuelling

Lubricating the chain

During operation there must always be sufficient chain oil in

the chain-oil tank to provide good chain lubrication. One filling

is sufficient for about one half-hour of continuous operation.

fuel/oil mixturechain oil

Adjusting the chain lubrication

The engine must be switched off.

You can adjust the oil pump feed rate with the adjusting screw

(F/1). The adjusting screw is located in the housing underneath

the sprocket guard (F/2). It is accessible from below.

The oil pump comes factory-set to a medium feed rate.

Note: To set from minimum to maximum oil supply, turn the

adjusting screw (F/1

with adjustment markings) a 1/4-turn.

To ensure troublefree operation of the oil pump the oil guide

groove at the crank case (G/3) and the oil inlet bore in the guide

bar (G/4) must be cleaned regularly.

To change the feed quantity use the universal wrench and

adjust the adjusting screw (F/1) in the following way:

- Turn to the right to reduce the feed rate.

- Turn to the left to increase the feed rate.

Note: After the saw has been turned off it is normal for

residual chain oil to drip from the oil feed system, the guide

bar and the chain for a time. This does

not constitute a defect!

Place the saw on a suitable surface.

FOLLOW THE SAFETY PRECAUTIONS!

Be careful and cautious when handling fuels.

The engine must be switched off!

- Thoroughly clean the area around the caps, to prevent dirt

from getting into the fuel or oil tank.

- Unscrew the cap and fill the tank with fuel (fuel/oil mixture)

or chain oil as the case may be. Fill up to the bottom edge

of the filler neck. Be careful not to spill fuel or chain oil!

- Tightly screw on the cap.

Clean screw cap and tank after refuelling.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 33 34

Commentaires sur ces manuels

Pas de commentaire

Makita DCS 6800I Manuel d'utilisateur Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Outil à essence Makita DCS 6800I