Makita UML03D Manuel d'instructions

Battery-Powered Grass Shear 100 mm (4”) MODEL UMl03D 100 mm (4”) MODEL UMl03DST With Battery & Charger INSTRUCTION MANUAL Effective cutting width

MAINTENANCE CAUTION : Always be sure that the tool is switched off and the battery is disconnected from the tool before attempting to perform inspect

When installing the new blades, rotate the I gear so that its ring is positioned in the blade guide hole. With the blades held Ring I in thi

ACCESSORIES CAUTION : These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any

Dec.-19-'94 US 100 mm (4") Model UM103D BATTERY-POWERED GRASS SHEAR Note: The switch and other part configurations may differ from country

Dec.-19-’94 US MODEL UMlO3D 14 21 31 41 51 61 71 81 ‘:,‘OM ,& DESCRIPTION 10 11 12 13 14 15 16 $2D OESCRIPTION 91 1 1 1 1 1 4 1 Tapping Screw 4x20

15

Recycling the battery The only way to dispose of a Makita battery is to recycle it. The law prohibits any other method of disposal. To recycle the

IMPORTANT SAFETY INSTRUCTIONS (For Gardenina Atmliances) WARNING: WHEN USING ELECTRIC TOOLS, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO RE

operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any

IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY & CHARGER -~ Length of Cord (Feet) AWG Size of Cord I. SAVE THESE INSTRUCTIONS - This manual contains

ADDITIONAL SAFETY RULES FOR BATTERY 1. Always charge the Makita battery 122 immediately after purchase. 2. Always recharge the Makita battery 122

ADDITIONAL SAFETY RULES FOR CHARGER 1. The Makita charger Model DC122 is specifically designed to charge only the Makita battery 121 or 122. Do not

DC122 122 Approx. 1 hour 121 Approx. 2 hours 4, u/ Adaptor cord--, DC121 Approx. 2 hours Approx. 4 hours Connector Adaptor cord Inlet CAUTION : 0 Alwa

Switch action To prevent the trigger from being acciden- tally pulled, a lock-off button is provided. To start the tool, push in the lock-off

0 per at ion Turn the tool on and hold it so that the "foot" of the tool rests on the ground. Then gently move the tool forwar