Makita AT2550A Manuel d'utilisation et d'entretien télécharger pdf (Page 5)

When an air set is not used, oil the tool with pneumatic

tool oil by placing 2 (two) or 3 (three) drops into the air fit-

ting. This should be done before and after use. For

proper lubrication, the tool must be fired a couple of

times after pneumatic tool oil is introduced.

FUNCTIONAL DESCRIPTION

CAUTION:

• Always disconnect the hose before adjusting or

checking function on the tool.

Adjusting depth of stapling

To adjust the depth of stapling, loosen the bolt by using

the hex wrench provided with the tool and then slide the

depth adjusting plate up or down.

If staples cannot be driven deep enough, slide the adjust-

ing plate in the direction of arrow as shown in the figure.

If the staples are driven too deep, slide the adjustinhg

plate in the direction of arrow as shown in the figure.

The depth can be adjusted 5 mm to the maximum.

Tighten the bolt securely at the right position after adjust-

ing.

ASSEMBLY

CAUTION:

• Always disconnect the hose before carrying out any

work on the tool.

Hook

CAUTION:

• Always disconnect the hose from the tool.

• Never hook the tool at high location or on potentially

unstable surface.

The hook is convenient for hanging the tool temporarily.

Secure the hook on the tool with the provided screw

using either of two holes in the hook as shown in the fig-

ure.

Loading stapler

CAUTION:

• Always disconnect the hose before loading the tool.

• Do not use deformed staples or staple strip. Failure

to do so causes poor staple feeding.

• Always use staples specified in this instruction

manual. Failure to do so causes poor staple feed-

ing.

• Always return the pusher slowly and gently while

holding it with a hand.

Select staples suitable for your work. Make sure that the

hose is disconnected from the tool.

1. Pull the pusher to the rear of magazine and hook

the groove in the pusher on the lock pin.

1. Depth adjusting

plate

2. Hex wrench

007200

007202

007201

1. Hook

2. Screw

1. Lock pin

2. Pusher

007315

007211

1 2 3 4 5 6 7 8 9 10 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Makita AT2550A Manuel d'utilisation et d'entretien Page 5

Commentaires sur ces manuels