Makita DCS232T Manuel d'instructions télécharger pdf (Page 16)

Electrode gap

The electrode gap must be 0.6 – 0.7 mm.

Cleaning the inlet port of the cooling air

Unscrew four screws (2). Remove recoil starter (3).

Clean the inlet port (4) and the cylinder fins.

Cleaning the muffler

CAUTION: If the engine is hot there is a risk of burning. Wear protective gloves.

Remove the sprocket cover (see “PUTTING INTO OPERATION”).

Remove deposits of carbon from the exhaust outlets (11) of the muffler.

Cleaning the cylinder space

Remove the sprocket cover (see “PUTTING INTO OPERATION”).

If necessary remove muffler by loosening and removing the two screws (14).

Stuff a rag into the cylinder port (15).

Use a suitable tool (wooden scraper) to clean out the cylinder space (16), especially the cooling

fins.

Remove the rag from the cylinder port and refit the muffler according to the diagram.

Replace the gasket (13) if necessary. Carefully remove any pieces of the old gasket from the muf-

fler.

Ensure correct mounting position. The cowling should follow the contour of the cylinder to

ensure correct heat transfer.

Tighten screws (14) to 10 Nm while the engine is cold.

0.6 – 0.7 mm

STOP

1 2 ... 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Makita DCS232T Manuel d'instructions Page 16