Makita HM1242C Manuel d'utilisateur télécharger pdf (Page 8)

Installing or removing the bit

This tool accepts 3/4” Hexagonal and 21/32” round shank

bits.

Clean the bit shank and apply bit grease before installing the

bit.

Pull the tool holder cover down all the way. With the cut in the

bit shank aligned with the notch in the tool holder cap, insert

the bit into the tool holder.

Release the tool holder cover. It will return automatically to

its original position to secure the bit. After installing, always

make sure that the bit is securely held in place by trying to

pull it out.

To remove the bit, pull the tool holder cover down all the way

and pull the bit out.

Bit angle

The bit can be secured at 12 different angles. To change the

bit angle, slide the change ring forward, then turn the change

ring to change the bit angle. At the desired angle, slide the

change ring back to the original position. The bit will be

secured in place.

NOTE:

• The change ring cannot turn when the bit is not installed

on the tool.

1. Bit grease

2. Bit shank

002919

1. Bit

2. Tool holder cover

3. Tool holder cap

4. Notch

002920

002921

1. Change ring

002940

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Makita HM1242C Manuel d'utilisateur Page 8