Makita HR2810T Manuel d'instructions télécharger pdf (Page 8)

output shaft. When this happens, the bit will stop turning.

CAUTION:

• As soon as the torque limiter actuates, switch off

the tool immediately. This will help prevent

premature wear of the tool.

• Bits such as hole saw, which tend to pinch or

catch easily in the hole, are not appropriate for this

tool. This is because they will cause the torque

limiter to actuate too frequently.

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and

unplugged before carrying out any work on the

tool.

Side grip (auxiliary handle)

008209

CAUTION:

• Always use the side grip to ensure operating

safety.

Install the side grip so that the teeth on the grip fit in

between the protrusions on the tool barrel. Then tighten

the grip by turning clockwise at the desired position. It

may be swung 360° so as to be secured at any position.

Bit grease

Coat the bit shank head beforehand with a small

amount of bit grease (about 0.5 - 1 g).

This chuck lubrication assures smooth action and longer

service life.

Installing or removing the bit

003150

Clean the bit shank and apply bit grease before

installing the bit.

008210

Insert the bit into the tool. Turn the bit and push it in until

it engages.

After installing, always make sure that the bit is securely

held in place by trying to pull it out.

To remove the bit, pull the chuck cover down all the way

and pull the bit out.

008211

Bit angle (when chipping, scaling or

demolishing)

For models HR2810, HR2810T, HR2811F, HR2811FT

008237

The bit can be secured at the desired angle. To change

the bit angle, rotate the action mode changing knob to

the O symbol. Turn the bit to the desired angle.

Rotate the action mode changing knob to the

symbol.

Then make sure that the bit is securely held in place by

turning it slightly.

008208

1. Action mode

changing knob

1. Action mode

changing knob

1. Bit

2. Chuck cover

1. Bit

2. Chuck cover

1. Bit shank

2. Bit grease

1. Grip base

2. Side grip

3. Teeth

4. Protrusion

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Makita HR2810T Manuel d'instructions Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Marteaux rotatifs Makita HR2810T