Makita HP1500 Manuel d'utilisateur

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.www.makitatools.comH

10Drilling in metalTo prevent the bit from slipping when starting a hole, makean indentation with a center-punch and hammer at the pointto be drilled.

Memo11

Memo12

13First-ClassPostageRequiredPost Office willnot deliverwithout properpostage.Makita U.S.A., Inc.14930 Northam StreetLa Mirada, CA 90638-5753FoldCut

141. This product was purchased from:Home CenterHardware/Lumber StoreTool DistributorIndustrial SupplyConstruction SupplyOther ( )

15FACTORY SERVICE CENTERS1-800-4-MAKITARETAIN THIS PORTION FOR YOUR RECORDSARIZONA3707 E. Broadway Rd., Ste. 6 Phoenix, AZ 85040 (602) 437-2850CALIFOR

WARNINGSome dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Calif

2SPECIFICATIONS• Manufacturer reserves the right to change specifications without notice.• Specifications may differ from country to country.GENERAL S

3trician to install a polarized outlet. Do notchange the plug in any way. Double insula-tion eliminates the need for the three wiregrounded power co

422.Use only accessories that are recom-mended by the manufacturer for yourmodel. Accessories that may be suitable forone tool, may become hazardous w

55.Do not leave the tool running.Operate the tool only when hand-held.6.Do not touch the bit or the workpieceimmediately after operation; they may bee

6FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function on thetool.Switch act

7Selecting the action modeThis tool has an action mode changing button.For rotation with hammering, depress the button from theside with symbol fully.

8For Model HP1500To install the bit, place it in the chuck as far as it will go.Tighten the chuck by hand. Place the chuck key in each ofthe three hol

9ping away from the hole.Do not apply more pressure when the hole becomes cloggedwith chips or particles. Instead, run the tool at an idle, thenremove