Makita DJV181 Manuel d'instructions télécharger pdf (Page 9)

013884

To tilt the base, loosen the bolt on the back of the base

with the hex wrench. Move the base so that the bolt is

positioned in the center of the bevel slot in the base.

013935

Tilt the base until the desired bevel angle is obtained.

The V-notch of the gear housing indicates the bevel

angle by graduations. Then tighten the bolt firmly to

secure the base.

Front flush cuts

013886

Loosen the bolt on the back of the base with the hex

wrench and slide the base all the way back. Then

tighten the bolt to secure the base.

Cutouts

Cutouts can be made with either of two methods A or B.

A) Boring a starting hole:

013887

•

For internal cutouts without a lead-in cut from an

edge, pre-drill a starting hole 12 mm (1/2") or more

in diameter. Insert the blade into this hole to start

your cut.

B) Plunge cutting:

013936

•

You need not bore a starting hole or make a lead-

in cut if you carefully do as follows.

1. Tilt the tool up on the front edge of the base with

the blade point positioned just above the

workpiece surface.

2. Apply pressure to the tool so that the front edge

of the base will not move when you switch on the

tool and gently lower the back end of the tool

slowly.

3. As the blade pierces the workpiece, slowly lower

the base of the tool down onto the workpiece

surface.

4. Complete the cut in the normal manner.

Finishing edges

013937

To trim edges or make dimensional adjustments, run the

blade lightly along the cut edges.

1. Starting hole

1. Base

2. Hex wrench

3. Bolt

1. Bevel slot

2. Base

3. Bolt

4. Graduations

5. V-notch

6. Gear housing

1. Base

2. Hex wrench

3. Bolt

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Makita DJV181 Manuel d'instructions Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Puzzles sans fil Makita DJV181