Makita 1912B Spécifications

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.www.makitatools.comP

10First, loosen the two wing nuts on the holder and insert theblades (A) and (B), so that they contact the sides (C) and (D).Then tighten the wing nut

11ACCESSORIESCAUTION:• These accessories or attachments are recommended foruse with your Makita tool specified in this manual. Theuse of any other acc

Memo12

13First-ClassPostageRequiredPost Office willnot deliverwithout properpostage.Makita U.S.A., Inc.14930 Northam StreetLa Mirada, CA 90638-5753FoldCut

141. This product was purchased from:Home CenterHardware/Lumber StoreTool DistributorIndustrial SupplyConstruction SupplyOther ( )

15FACTORY SERVICE CENTERS1-800-4-MAKITARETAIN THIS PORTION FOR YOUR RECORDSARIZONA3707 E. Broadway Rd., Ste. 6 Phoenix, AZ 85040 (602) 437-2850CALIFOR

WARNINGSome dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Calif

2SPECIFICATIONS• Manufacturer reserves the right to change specifications without notice.• Specifications may differ from country to country.GENERAL S

35.Avoid body contact with grounded sur-faces such as pipes, radiators, ranges andrefrigerators. There is an increased risk ofelectric shock if your b

4SERVICE23.Tool service must be performed only byqualified repair personnel. Service or main-tenance performed by unqualified personnelcould result in

510.Keep at least 200 mm (8") away from thetool at all times.11.Always switch off and wait for the bladesto come to a complete stop before anyadj

6FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function on thetool.Adjusting

7To install the blades, first clean out all chips or foreign matteradhering to the drum or blades. Use blades of the samedimensions and weight, or dru

8For the correct planer blade settingYour planing surface will end up rough and uneven, unlessthe blade is set properly and securely. The blade must b

9ChamferingTo make a cut as shown in the figure, align the “V’’ groove inthe front base with the edge of the workpiece and plane it asshown in the fig