Makita 2702 Spécifications télécharger pdf

Model 2702 2703

2702x1 2703x1

Blade diameter .......................................... 210 mm 255 mm

Hole (arbor) diameter ................................ 25 mm 25 mm

Cutting capacities ...................................... 90°: 68 mm 91 mm

45°: 47 mm 63 mm

Table size (W x L) ..................................... 686 mm x 560 mm 686 mm x 560 mm

No load speed (RPM) ............................... 4,600 4,600

Dimensions (L x W x H) ............................ 560 mm x 686 mm x 458 mm 560 mm x 686 mm x 458 mm

Net weight ................................................. 18 kg 18 kg

Due to the continuing program of research and development, the specifications herein are subject to change without

prior notice.

Note: Specifications may differ from country to country.

Power supply

The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only

be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can,

therefore, also be used from sockets without earth wire.

Table Saw

210 mm 2702

2702x1

255mm 2703

2703x1

SPECIFICATIONS

1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1 - 255mm 2703

Model 2702 27032702x1 2703x1Blade diameter ... 210 mm 255 mm Hole (arbor) diameter ...

Page 2

10Adjusting positive stops The tool is equipped with positive stops at 90° and 45° tothe table surface. To check and adjust the positive stops,proceed

Page 3 - 12-A 12-B

11Ripping CAUTION: •When ripping, remove the miter gauge from the table. • When cutting long or large workpieces, always provideadequate support behin

Page 4

Makita CorporationAnjo, Aichi, Japan884129B8

Page 5

21234567819181711613111215141610111212945768132

Page 6 - DOUBLE INSULATION

3910111213 14302829259090454512-A 12-B2627239324252220 21

Page 7

415 1617 1819 2021 22371838343035362323329AB31

Page 8 - SAVE THESE INSTRUCTIONS

523 2425 2627 2829 30515049434445464847424141424039

Page 9 - OPERATING INSTRUCTIONS

6SymbolsThe followings show the symbols used for the tool. Be sure that you understand their meaning before use.❏Read instruction manual. ❏DOUBLE INSU

Page 10

7ENGLISH Explanation of general view 1Offset wrench 13-22 2Wrench 19 3 Loosen 4Inner flange 5Ring 6Saw blade 7Outer flange 8 Hex nut 9Tighten 10 Blade

Page 11 - ACCESSORIES

820. Check damaged parts Before further use of the tool, a guard or other partthat is damaged should be carefully checked todetermine that it

Page 12 - Makita Corporation

9OPERATING INSTRUCTIONS The tool is shipped from the factory with the saw blade and blade guard not in the installed condition. Assemble as fol-lows.