Makita HR5001C Manuel d'utilisateur télécharger pdf (Page 5)

• The speed adjusting dial can be turned only as far

as 6 and back to 1. Do not force it past 6 or 1, or the

speed adjusting function may no longer work.

Selecting the action mode

Rotation with hammering

For drilling in concrete, masonry, etc., depress the lock

button and rotate the change lever so that the pointer

points to the symbol. Use a tungsten-carbide tipped

bit.

Hammering only

For chipping, scaling or demolition operations, depress

the lock button and rotate the change lever so that the

pointer points to the symbol. Use a bull point, cold

chisel, scaling chisel, etc.

CAUTION:

• Do not rotate the change lever when the tool is run-

ning under load. The tool will be damaged.

• To avoid rapid wear on the mode change mecha-

nism, be sure that the change lever is always posi-

tively located in one of the two action mode

positions.

Torque limiter

The torque limiter will actuate when a certain torque level

is reached. The motor will disengage from the output

shaft. When this happens, the bit will stop turning.

CAUTION:

• As soon as the torque limiter actuates, switch off

the tool immediately. This will help prevent prema-

ture wear of the tool.

Indicator lamp

The green power-ON indicator lamp lights up when the

tool is switched ON. If the indicator lamp is lit but the tool

does not start, the carbon brushes may be worn out, or

the electric circuit or the motor may be defective. If the

indicator lamp does not light up and the tool does not

start, the ON/OFF switch or the mains cord may be

defective.

The red service indicator lamp lights up when the carbon

brushes are nearly worn out to indicate that the tool

needs servicing. After approx. 8 hours of use, the motor

will automatically be shut off.

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and

unplugged before carrying out any work on the tool.

Side handle

CAUTION:

• Use the side handle only when chipping, scaling or

demolishing. Do not use it when drilling in concrete,

masonry, etc. The tool cannot be held properly with

this side handle when drilling.

The side handle can be swung 360° on the vertical and

secured at any desired position. It also secures at eight

different positions back and forth on the horizontal. Just

loosen the clamp nut to swing the side handle to a

desired position. Then tighten the clamp nut securely.

1. Change lever

2. Pointer

3. Lock button

1. Pointer

2. Change lever

003130

003135

1. Service indica-

tor lamp (red)

2. Power-ON indi-

cator lamp

(green)

003138

003139

1 2 3 4 5 6 7 8 9 10 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Makita HR5001C Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Makita HR5001C