Makita HR5001C Manuel d'utilisateur télécharger pdf (Page 8)

should be replaced at the same time. Use only identical

carbon brushes.

Use a screwdriver to remove the brush holder cover.

Use a screwdriver to remove the brush holder caps. Take

out the worn carbon brushes, insert the new ones and

secure the brush holder caps.

Lubrication

CAUTION:

• This servicing should be performed by Makita

Authorized or Factory Service Centers only.

This tool requires no hourly or daily lubrication because it

has a grease-packed lubrication system. It should be

relubricated every time the carbon brushes are replaced.

Send the complete tool to Makita Authorized or Factory

Service Center for this lubrication service.

Run the tool for several minutes to warm it up. Switch off

and unplug the tool.

Loosen the six screws and remove the handle.

Disconnect the connector by pulling it.

Remove the crank cap using a hex wrench. Rest the tool

on the table with the bit end pointing upwards. This will

allow the old grease to collect inside the crank housing.

Wipe out the old grease inside and replace with a fresh

grease (90 g; 3 oz). Use only Makita genuine hammer

grease (optional accessory). Filling with more than the

specified amount of grease (approx. 90 g; 3 oz) can

cause faulty hammering action or tool failure. Fill only

with the specified amount of grease.

Reinstall the crank cap and tighten with the hex wrench.

Connect the connector and reinstall the handle.

1. Screwdriver

2. Brush holder

cover

1. Screwdriver

2. Brush holder

cap

1. Screws

003226

003232

003237

1. Black

2. Connector

3. White

1. Hex wrench

2. Crank cap

1. Hammer grease

1. Connector

2. Black

3. White

003583

003243

003247

003250

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Makita HR5001C Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Makita HR5001C