Makita BLS820 Spécifications télécharger pdf (Page 30)

Replacing carbon brushes

Remove and check the carbon brushes regularly. Replace

when they wear down to the limit mark. Keep the carbon

brushes clean and free to slip in the holders. Both carbon

brushes should be replaced at the same time. Use only iden-

tical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take out

the worn carbon brushes, insert the new ones and secure

the brush holder caps.

After replacing brushes, insert the battery cartridge into the

tool and break in brushes by running tool with no load for

about 1 minute. Then check the tool while running and elec-

tric brake operation when releasing the switch trigger. If elec-

tric brake is not working well, ask your local Makita service

center for repair.

After use

• After use, wipe off chips and dust adhering to the tool

with a cloth or the like. Keep the blade guard clean

according to the directions in the previously covered

section titled “Blade guard”. Lubricate the sliding

portions with machine oil to prevent rust.

To maintain product SAFETY and RELIABILITY, repairs, any

other maintenance or adjustment should be performed by

Makita Authorized or Factory Service Centers, always using

Makita replacement parts.

1. Limit mark

001145

1. Screwdriver

2. Brush holder cap

001822

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

Makita BLS820 Spécifications Page 30