Makita LS1220 Spécifications télécharger pdf (Page 25)

Lower the handle fully and lock it in the lowered position

by pushing in the stopper pin. Square the side of the

blade with the face of the guide fence using a triangular

rule, try-square, etc. Then securely tighten the hex bolts

on the guide fence in the order from the right side.

Make sure that the pointer points to 0° on the miter

scale. If the pointer does not point to 0°, loosen the

screw which secures the pointer and adjust the pointer

so that it will point to 0°.

2. Bevel angle

(1) 0° bevel angle

Lower the handle fully and lock it in the lowered

position by pushing in the stopper pin. Loosen the

lever at the rear of the tool.

Tur n the 0 ° bevel angle adjusting bolt on the left

side of the turn base two or three revolutions coun-

terclockwise to tilt the blade to the right.

Carefully square the side of the blade with the top

surface of the turn base using the triangular rule,

try-square, etc. by turning the 0° bevel angle adjust-

ing bolt clockwise. Then tighten the lever securely.

1. Triangular rule

2. Guide fence

3. Grip

001848

1. Miter scale

2. Pointer

3. Grip

4. Lock lever

001836

1. Lever

2. Turn base

3. 0° bevel angle adjusting bolt

001850

1. Triangular rule

2. Saw blade

3. Top surface of turn base

001819

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Makita LS1220 Spécifications Page 25