Makita LS1220 Spécifications télécharger pdf (Page 8)

If the see-through blade guard becomes dirty, or sawdust

adheres to it in such a way that the blade is no longer easily

visible, unplug the saw and clean the guard carefully with a

damp cloth. Do not use solvents or any petroleum-based

cleaners on the plastic guard.

If the blade guard is especially dirty and vision through the

guard is impaired, use the supplied socket wrench to loosen

the hex bolt holding the center cover. Loosen the hex bolt by

turning it counterclockwise and raise the blade guard and

center cover. With the blade guard so positioned, cleaning

can be more completely and efficiently accomplished. When

cleaning is complete, reverse procedure above and secure

bolt. Do not remove spring holding blade guard. If guard

becomes discolored through age or UV light exposure, con-

tact a Makita service center for a new guard. DO NOT

DEFEAT OR REMOVE GUARD.

Positioning kerf board

This tool is provided with the kerf boards in the turn base to

minimize tearing on the exit side of a cut. The kerf boards are

factory adjusted so that the saw blade does not contact the

kerf boards. Before use, adjust the kerf boards as follows:

First, unplug the tool. Loosen all the screws (2 each on left

and right) securing the kerf boards. Re-tighten them only to

the extent that the kerf boards can still be easily moved by

hand. Lower the handle fully and push in the stopper pin to

lock the handle in the lowered position. Adjust the kerf

boards so that the kerf boards just contact the sides of the

blade teeth. Tighten all the screws (do not tighten firmly).

After adjusting the kerf boards, release the stopper pin and

raise the handle. Then tighten all the screws securely.

CAUTION:

• Before and after changing the bevel angle, always adjust

the kerf boards as described above.

1. Blade guard

001782

1. Kerf board

2. Screw

1. Saw blade

2. Blade teeth

3. Kerf board

4. Left bevel cut

5. Straight cut

001834

001800

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Makita LS1220 Spécifications Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à onglets Makita LS1220