Makita 1002BA Manuel d'instructions télécharger pdf (Page 5)

Removing or installing planer blades

CAUTION:

Always be sure that the tool is switched off and unplugged before removing or installing

the blade.

remove the blades on the drum, un-

screw the four installation bolts with the

socket wrench. The drum cover comes off

together with the blades.

To install the blades, first clean out all chips

or foreign matter adhering to the drum or

blades. Use blades of the same dimensions

and weight, or drum oscillation/vibration

will

result, causing poor planing action and

eventually tool breakdown.

Place the blade on the gauge base

that

the blade edge is perfectly flush with the

inside edge of the gauge plate. Place the

adjusting plate on the blade, then simply

press in the heel of the adjusting plate flush

with the back side of the gauge base and

tighten two screws on the adjusting plate.

Now slip the heel of the adjusting plate into

the drum groove, then fit the drum cover

it.

Tigkten the three installation bolts

evenly and alternately with the socket

wrench.

Bolt

Drum

Planer blac

Drum

Adjusting plate

gauge plate

base

CAUTION:

Tighten the blade installation bolts carefully when attaching the blades to the tool. A loose

installation bolt can be dangerous. Always check to see they are tightened securely.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Makita 1002BA Manuel d'instructions Page 5