Makita EBH341U Manuel d'instructions télécharger pdf (Page 15)

㩿㪉㪀

㩿㪈㪀

STOP

Note: – If the starter handle is pulled repeatedly when the choke lever remains at “CLOSE” position, the engine will not start easily due to

excessive fuel intake.

– In case of excessive fuel intake, remove the spark plug and pull the starter handle slowly to remove excess fuel. Also, dry the electrode

section of the spark plug.

Caution during operation:

If the throttle lever is opened fully in a no-load operation, the engine rotation is increased to 10,000 min

-1

or more. Never operate the engine at a

higher speed than required and at an approximate speed of 6,000 - 8,500 min

-1

Carburetor

Primer Pump

4) Primer pump

Continue to push the primer pump until fuel enters into the primer pump. (In

general, fuel enters into the primer pump by 7 to 10 pushes.)

If the primer pump is pushed excessively, an excess of gasoline returns to

the fuel tank.

5) Recoil starter

Pull the start knob gently until it is hard to pull (compression point). Then,

return the start knob, and pull it strongly.

Never pull the rope to the full. Once the start knob is pulled, never release

your hand immediately. Hold the start knob until it returns to its original

point.

6) Choke lever

When the engine starts, open the choke lever.

– Open the choke lever progressively while checking the engine operation.

Be sure to open the choke lever to the full in the end.

– In cold or when the engine is cooled down, never open the choke lever

suddenly. Otherwise, the engine may stop.

7) Warm-up operation

Continue warm-up operation for 2 to 3 minutes.

B: Startup after warm-up operation

1) Push the primer pump repeatedly.

2) Keep the throttle lever at the idling position.

3) Pull the recoil starter strongly.

4) If it is difﬁcult to start the engine, open the throttle by about 1/3.

Pay attention to the cutter blade which may rotate.

STOPPING

1) Release the throttle lever (2) fully, and when the engine

rpm has lowered, set the I-O switch to STOP the engine

will now stop.

2) Be aware that the cutting head may not stop

immediately and allow it to slow down fully.

(1)

STOP

(2)

Attention in Operation

When the engine is operated upside down, white smoke may come out from the mufﬂer.

OPEN

EBH341L EBH341U

(2)

(1)

STOP

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 231 232

Commentaires sur ces manuels

Pas de commentaire

Makita EBH341U Manuel d'instructions Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Outils de jardin Makita EBH341U