Makita AN450H Manuel d'instructions télécharger pdf (Page 6)

ENGLISH

Explanation of general view

SPECIFICATIONS

• Due to our continuing program of research and development, the specifications herein are subject to change without

notice.

• Note: Specifications may differ from country to country.

Symbols

END106-2

The following show the symbols used for the equipment.

Be sure that you understand their meaning before use.

............. Read instruction manual.

............. Wear safety glasses.

............. Do not use on scaffoldings, ladders.

Intended use

ENE059-1

The tool is intended for the preliminary interior work such

as fixing floor joists or common rafters and framing work

in 2“ x 4” housing.

IMPORTANT SAFETY

INSTRUCTIONS ENB109-2

IMPORTANT SAFETY INSTRUCTIONS WARNING:

WHEN USING THIS TOOL, BASIC SAFETY

PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO

REDUCE THE RISK OF PERSONAL INJURY,

INCLUDING THE FOLLOWING:

READ ALL INSTRUCTIONS.

• For personal safety and proper operation and

maintenance of the tool, read this instruction manual

before using the tool.

• Always wear safety glasses to protect your eyes from

dust or nail injury.

WARNING:

It is an employer's responsibility to enforce the use of

safety eye protection equipment by the tool operators

and by other persons in the immediate working area.

• For Australia and New Zealand only Always wear

safety glasses and face shield to protect your eyes

from dust or nail injury. The safety glasses and the face

shield should conform with the requirements of

AS/NZS 1336.

WARNING:

It is an employer's responsibility to enforce the use of

safety eye protection equipment by the tool operators

and by other persons in the immediate working area.

(Fig. 1)

• Wear hearing protection to protect your ears against

exhaust noise and head protection. Also wear light but

not loose clothing. Sleeves should be buttoned or

rolled up. No necktie should be worn.

• Rushing the job or forcing the tool is dangerous.

Handle the tool carefully. Do not operate when under

the influence of alcohol, drugs or the like.

• General Tool Handling Guidelines:

(1) Always assume that the tool contains fasteners.

(2) Do not point the tool toward yourself or anyone

whether it contains fasteners or not.

(3) Do not activate the tool unless the tool is placed

firmly against the workpiece.

(4) Respect the tool as a working implement.

(5) No horseplay.

(6) Do not hold or carry the tool with a finger on the

trigger.

1. Safety glasses

2. Face shield

3. Compressor air output per minute

4. Nailing frequency

5. Pneumatic oil

6. Adjuster

7. Hook

8. Contact element

9. Shingle guide

10. Shingle

11. Projection

12. Lever

13. Adjust plate

14. Magazine cap

15. Latch lever

16. Coil support plate

17. Graduation

18. Arrow

19. Feed Claw

20. Air fitting

21. Air socket

22. Trigger

23. Workpiece

24. Change lever

25. Small rod

26. Ejection port

27. Cap

28. Drain cock

29. Air filter

30. Oiler

Model AN450H

Air pressure 1.28 - 2.26 Mpa (12.8 - 22.6 bar)

Nail length 19 mm - 45 mm

Nail capacity 120 pcs.

Min. hose diameter 5.0 mm

Pneumatic tool oil Turbine oil

Dimensions (L X H X W) 287 mm X 276 mm X 117 mm

Net weight 2.2 kg

1 2 3 4 5 6 7 8 9 10 11 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Makita AN450H Manuel d'instructions Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Makita AN450H