Makita BLS712SFE Manuel d'instructions télécharger pdf (Page 17)

Vertical vise

The vertical vise can be installed in two

positions on either the left or right side

of the guide fence, or the holder assem-

bly (optional accessory).

Insert the vise rod into the hole in the

guide fence or the holder assembly and

tighten the screw to secure the vise rod.

(Note: When using the holder

assembly,

install it on the holder as shown in the

figure.)

Position the vise arm according to the

thickness and shape of the workpiece

and secure the vise

arm

by tightening

the screw.

Holder Holder assembly Turn base

Make sure that

part of the tool contacts the vise when lowering the handle fully or

when pulling or pushing the carriage.

some part contacts the vise, re-position the

vise. Press the workpiece flat against the guide fence and the turn base. Position the

workpiece at the desired cutting position and secure it firmly by tightening the vise

knob. The maximum thickness of workpieces which can be secured by the vertical vise

(2").

Horizontal

vise

(optional accessory)

The horizontal vise can be installed on the left side of the base.

turning the vise knob

counterclockwise, the screw

released and the vise shaft can be moved rapidly in and

out.

grip workpieces, turn the vise knob gently clockwise until the projection reaches

its topmost position, then fasten securely.

the vise knob is forced in or pulled out

while being turned clockwise, the projection may stop at an angle. In this case, turn the

vise knob back counterclockwise until the screw is released, before turning again gently

clockwise. The maximum width of workpieces which can be secured by the horizontal

vise

120

(4-3/4")

Vise knob

Vise shaft

Projection

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 32 33

Commentaires sur ces manuels

Pas de commentaire

Makita BLS712SFE Manuel d'instructions Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à onglets Makita BLS712SFE