*There are crown and cove molding joints which
are
made to fit "Inside"
90"
corners
(0
and
0)
in Fig.
C)
and "Outside"
90"
corners
(@
and
@
in Fig. C).
Bevel angle
Molding position
in Fig. (C) 52/38O type 45O type
0
0
0
@I
For inside corner
~
Left 30°
Left 33.9'
For outside corner
-
Inside corner Outside corner
I
Miter angle
52/38' type 45O type
Right 31.6' Right 35.3O
Left 31.6' Left
35.3'
Right 31.6'' Right 35.3'
I
Fig.
(Ct
Molding
position
in Fig. (C)
Molding edge against guide fence
Ceiling contact edge should be
against guide fence.
For inside corner
Inside cornel
Finished piece
Finished piece will be on the
Left side
of
blade.
0
0
@I
For outside corner
Wall contact edge should be
against guide fence.
Finished piece will
be
on the
Right
side
Of
blade.
Ceiling contact edge should be
against guide fence.
(Example)
In the case of cutting
52/38O
type crown molding for position
@
in Fig.
(C):
*Tilt and secure bevel angle setting to
33.9"
LEFT.
*Adjust and secure miter angle setting to
31.6"
RIGHT.
*Lay crown molding with its broad back surface down on the turn base with its CEIL-
*The finished piece to be used will always be on the LEFT side
of
the blade after the
ING CONTACT
EDGE
against the guide fence on the saw.
cut has been made.
22
Commentaires sur ces manuels