Makita DCS3410TH Manuel d'instructions télécharger pdf (Page 14)

Refuelling

FOLLOW THE SAFETY PRECAUTIONS!

Be careful and cautious when handling fuels.

The engine must be switched off!

Thoroughly clean the area around the caps, to prevent dirt from

getting into the fuel or oil tank.

Unscrew the cap and ﬁ ll the tank with fuel (fuel/oil mixture) or

chain oil as the case may be. Fill up to the bottom edge of the

ﬁ ller neck. Be careful not to spill fuel or chain oil!

Tighten the tank cap as far as it will go.

After refuelling, clean the tank cap and surroundings and

make sure the cap is sealed!

Lubricating the chain

During operation there must always be sufﬁ cient chain oil in

the chain-oil tank to provide good chain lubrication. One ﬁ lling

is sufﬁ cient for about one half-hour of continuous operation.

When working, check that there is still sufﬁ cient chain oil in the

tank and top up if necessary. Check only when the engine

is switched off!

waste oil

NEVER USE WASTE OIL

Waste oil is very dangerous for the environment.

Waste oil contains high amounts of carcinogenic substances.

Residues in waste oil result in a high degree of wear and tear

at the oil pump and the sawing device.

In case of damage caused by using waste oil or unappropriate

chain oil the product guarantee will be null and void.

Your salesman will inform you about the use of chain oil.

AVOID SKIN AND EYE CONTACT

Mineral oil products degrease your skin. If your skin comes in

contact with these substances repeatedly and for an extended

period of time, it will desiccate. Various skin deseases may result.

In addition, allergic reactions are known to occur.

Eyes can be irritated by contact with oil. If oil comes into your

eyes, immediately wash them with clear water.

If your eyes are still irritated, see a doctor immediately!

Important note on bio-degradable chain oils:

If you are not planning to use the saw again for an ex-

tended period of time, empty the oil tank and put in a

small amount of regular engine oil (SAE 30), and then

run the saw for a time. This is necessary to ﬂ ush out all

remaining bio-degradable oil from the oil tank, oil-feed

system, chain and guide bar, as many such oils tend to

leave sticky residues over time, which can cause damage

to the oil pump or other parts.

The next time you use the saw, ﬁ ll the tank with BIOTOP

chain oil again. In case of damage caused by using waste

oil or unappropriate chain oil the product guarantee will

be null and void.

Your salesman will inform you about the use of chain

oil.

fuel/oil mixture

chain oil

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Makita DCS3410TH Manuel d'instructions Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Makita DCS3410TH