Makita DCS3410TH Manuel d'instructions télécharger pdf (Page 24)

Cleaning the mufﬂ er

CAUTION: If the engine is hot there is a risk of burning.

Wear protective gloves.

Remove the sprocket guard (see ”PUTTING INTO OPERATI-

ON” Fig. B).

Remove deposits of carbon from the exhaust outlets (13) of

the mufﬂ er.

Cleaning the cylinder space

Remove the sprocket guard (see ”PUTTING INTO OPERATI-

ON” Fig. B).

If necessary remove mufﬂ er by loosening and removing the

three screws (16).

Stuff a rag into the cylinder port (17).

Use a suitable tool (wooden scraper) to clean out the cylinder

space (18), especially the cooling ﬁ ns.

Remove the rag from the cylinder port and reﬁ t the mufﬂ er

according to the diagram.

Replace the gasket (15) and cowling (14) if necessary. Carefully

remove any pieces of the old gasket from the mufﬂ er.

Ensure correct mounting position. The cowling should follow

the contour of the cylinder to ensure correct heat transfer.

Tighten screws (16) to 10 Nm while the engine is cold.s

Replacing the return spring unit

Remove and reinstall the fan housing and cable drum (see

”Replacing the starter cable”).

Carefully remove the return spring unit (9) from the fan

housing.

CAUTION:

Danger of injury! If the spring is broken it can jump out!

Carefully ﬁ t the new return spring unit.

1 2 ... 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Makita DCS3410TH Manuel d'instructions Page 24