Makita 5201NA Manuel d'utilisateur télécharger pdf (Page 7)

Adjusting depth of cut

CAUTION:

• After adjusting the depth of cut, always tighten the

lever securely.

Loosen the lever on the depth guide and move the base

up or down. At the desired depth of cut, secure the base

by tightening the lever.

For cleaner, safer cuts, set cut depth so that no more

than one blade tooth projects below workpiece. Using

proper cut depth helps to reduce potential for dangerous

KICKBACKS which can cause personal injury.

Bevel cutting

Loosen the clamping screw on the bevel scale plate on

the front of the base. Set for the desired angle (0° - 45°)

by tilting accordingly, then tighten the clamping screw

securely.

Sighting

For straight cuts, align the A position on the front of the

base with your cutting line. For 45° bevel cuts, align the B

position with it.

Switch action

CAUTION:

• Before plugging in the tool, always check to see

that the switch trigger actuates properly and returns

to the “OFF” position when released.

To prevent the switch trigger from being accidentally

pulled, a lock-off button is provided. To start the tool,

push in the lock-off button and pull the switch trigger.

Release the switch trigger to stop.

Electric brake

This tool is equipped with an electric blade brake. If the

tool consistently fails to quickly stop blade after switch

trigger release, have tool serviced at a Makita service

center.

The blade brake system is not a substitute for lower

guard. NEVER USE TOOL WITHOUT A FUNCTIONING

LOWER GUARD. SERIOUS PERSONAL INJURY CAN

RESULT.

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and

unplugged before carrying out any work on the tool.

Removing or installing saw blade

CAUTION:

• Be sure the blade is installed with teeth pointing up

at the front of the tool.

• Use only the Makita wrench to install or remove the

blade.

1. Lever

1. Bevel scale

plate

2. Clamping screw

1. Base

001347

001364

001382

1. Lock-off button

2. Switch trigger

1. Wrench

2. Hex wrench

001403

001424

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Makita 5201NA Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Makita 5201NA