Makita LS1220 Spécifications télécharger pdf (Page 10)

Adjusting the bevel angle

To adjust the bevel angle, loosen the lever at the rear of the

tool counterclockwise.

Push the handle to the left to tilt the saw blade until the

pointer points to the desired angle on the bevel scale. Then

tighten the lever clockwise firmly to secure the arm.

CAUTION:

• When tilting the saw blade, be sure to raise the handle

fully.

• After changing the bevel angle, always secure the arm

by tightening the lever clockwise.

• When changing bevel angles, be sure to position the kerf

boards appropriately as explained in the “Positioning kerf

boards” section.

Switch action

CAUTION:

• Before plugging in the tool, always check to see that the

switch trigger actuates properly and returns to the “OFF”

position when released.

• When not using the tool, remove the lock-off button and

store it in a secure place. This prevents unauthorized

operation.

• Do not pull the switch trigger hard without pressing in the

lock-off button. This can cause switch breakage.

To prevent the switch trigger from being accidentally pulled, a

lock-off button is provided. To start the tool, press in the lock-

off button and pull the switch trigger. Release the switch trig-

ger to stop.

WARNING:

• NEVER use tool without a fully operative switch trigger.

Any tool with an inoperative switch is HIGHLY

DANGEROUS and must be repaired before further

usage.

• For your safety, this tool is equipped with a lock-off

button which prevents the tool from unintended starting.

1. Lever

1. Pointer

2. Bevel scale

3. Lever

001837

001838

1. Lock-off button

2. Switch trigger

001833

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Makita LS1220 Spécifications Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à onglets Makita LS1220